Install bump cup, bump stop and dust cover to shock absorber. Install hub assembly to lower joint, fit new nut and tighten to 48 ft. Remove 4 screws securing steering wheel trim and remove trim pieces. Remove 3 bolts securing fluid cooler bracket. Always support the vehicle on safety stands. On the right side: Position coolant reservoir and secure with bolt. Detach the horn connector 7.
Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Ensure wheels are straight ahead and rotary coupler is locked in correct position. Remove the height sensor link. If irritation continues, see a physician. Clean drive shaft and flange splines. Replace the bolts attaching the lower arm to the sub-frame but do not tighten. See your local authorized Land Rover Retailer for details.
Remove the tank from the cradle. Intake Exhaust Intake Exhaust 20024. If 3 marks are found, axle case must be replaced. Using a bushing removal tool to remove the lower control arm front bushing-Freelander 2001-04 To install: 1. R Step 1: 7 ft.
Pull the transmission rearward, slightly, secure the torque converter to the transmission. Remove safety stands and lower the vehicle. Remove 2 nuts securing radius arm to axle. Secure the steering wheel, then loosen the self locking nut holding the steering wheel to the column. Remove the supports and lower vehicle.
Maecenas feugiat sapien odio, nec imperdiet felis placerat pretium. If more than 2 marks are found, the axle case must be renewed. Page 56 Back to Top 10. Before servicing the vehicle, be sure to also refer to the precautions in the beginning of this section as well. Disconnect the negative battery cable first, then the positive cable. Drain and recycle the engine coolant. Remove the fuel pump, then using a fuel recovery appliance, drain the fuel from the tank into a sealed container.
Remove 4 bolts securing left side mount to body and remove mount. Install the airbag module to steering wheel and tighten the TorxÂ® bolts to 7 ft. Oil Clearance Shaft End-play Thrust on No. If both require replacement, replace one, then perform the Airbag System test before replacing the other. Transmission oil cooler lines and secure them out of the way. Torque the upper nut to 81 ft. Position the steering wheel on the column.
Raise the axle until the spring is seated in the lower spring seat. Remove the height sensor link. Journal Diameter Oil Clearance Side Clearance 20032 2. Release drive shaft from hub. Using a bushing removal tool to remove the lower control arm front bushing-Freelander 2000-04 To install: 1. Disconnect the radio and cruise control connectors.
Fuel Pump psi Ignition Timing deg. Before servicing the vehicle, refer to the Precautions section. Print Land Rover 2000-05 Service Precautions Several precautions must be observed when handling the inflator module to avoid accidental deployment and possible personal injury. Loosen the upper bolt securing the shock to the tower. Loosen gear selector cable trunnion nut.