If it is loose, unscrew it, apply a non-permanent locking agent to the threads, and tighten it. If the guide pin on any shift fork is less than the service limit, the fork must be replaced. Return Fuel Check Valve 3. Good luck and have a wonderful day. The tip of each injector contains four nozzles, with two of those aimed at each intake valve. Replace the gasket if it is damaged. If all other starter mo- tor components and starter motor circuit components check good, but the starter motor still does not turn over or only turns over weakly, replace the starter motor with a new one.
Throttle Sensor front view 6. If the crankpin has worn past the service limit, replace the crankshaft with a new one. When the vacuum is low, the vacuum switch valve should permit air to flow. × L about 400 mm 15. Left Handlebar Switch Lead Connector 3. Brake Hose White Marks Position here.
The initial maintenance is vitally important and must not be neglected. Such a shock to the sensor can damage it. The rear brake pedal is designed to make it easier to apply the brake that has plenty of power with its dual piston caliper. Observe all the rules listed below: When removing the tensioner, do not take out the mounting bolts only halfway. Good luck and have a wonderful day. Do not remove the other spark plug, only the plug lead. Left Rubber Gasket the angle.
Good luck and have a wonderful day. A gear-driven engine counterbalancer and rubber engine mounts reduce handlebar and floorboard vibration, yet the engine retains its distinctive V-twin rumble. Right Air Cleaner Cover 2. If the coolant is brown, iron or steel parts are rusting. L: Apply a non-permanent locking agent. Fuel Level Warning Light 4.
Use this table for only the bolts and nuts which do not require a specific torque value. Main Fuse 30 A 9. When the engine starts, the water pump turns and the coolant circulates. Fuel Tank left view 2. Shim s for Preload 16.
Torque - Driven Gear Bolt: 118 N·m 12. Do not con- fuse the springs. I have ridden identical bikes, same year,same tire, and they all read the speed differently. Ignition Fuse 10 A 7. Torque - Spoke Nipples: 2. Engine Oil and Oil Filter. Ring Gear Oil Seal 7.
Be careful not to mix them up. Be careful not to scratch the sealing surface on the ring gear hub. Air, however, is easily compressed. Oil Pressure Warning Light Delay Unit 16. Spring Pin L: Apply a non-permanent locking agent. Silicone Sealant- Kawasaki Bond: 56019-120.
They may not indicate the correct air pressure because of air leakage that occur when the gauge is applied to the valve. Such a shock to the pump can damage it. Most of the manuals will cover your exact make, model, and year otherwise one will be provided that comes as close as possible to your bike and will have most of the same info that an exact manual would have. Good luck and have a wonderful day. The radiator fan may start even if the ignition switch is off. Rear Suspension: Type Swingarm Wheel Travel 95 mm 3. Good luck and have a wonderful day.